Cabletron Systems DELHF-UA, Руководство пользователя

Страница: 33 / 92

Installing an HSIM
DELHF-UA User’s Guide 2-5
provide generic instructions for installing a DELHF-UA in an interface
module or in a standalone hub. Refer to your specific interface module or
standalone hub documentation for exact HSIM slot and connector
locations.
2.3.1 Installing an HSIM in an Interface Module
To install a DELHF-UA in an interface module that supports HSIM
technology perform the following steps.
1. Note the ports of the interface module that have cables attached to
them. Then disconnect those cables from the ports.
2. Attach the antistatic wrist strap (refer to the instructions outlined in the
interface module User’s Guide).
3. Unlock the top and bottom plastic locking tabs of the module
faceplate.
4. Slide out the module, and place it on its side with the internal
components facing up.
5. Refer to Figure 2-3 and remove the two faceplate mounting screws and
the HSIM coverplate. Save the screws.
6. Refer to Figure 2-3 and remove the two standoff screws. Save the
screws.
!
The DELHF-UA and the host module or standalone hub are
sensitive to static discharges. Use an antistatic wrist strap and
observe all static precautions during this procedure. Failure to
do so could result in damage to the DELHF-UA, the host
module or standalone hub.