Cabletron Systems 9F426-02, Руководство пользователя

Страница: 19 / 36

2-5
Installing the SmartSwitch 9000 Module
Installing the Module into the SmartSwitch 9000
Chassis
To install the SmartSwitch 9000 module, follow the steps below:
1. Switch off the power supplies and remove all power from the SmartSwitch
9000 chassis.
2. Remove the blank panels, covering the slots that the module is being mounted
in. All other slots must be covered, if modules are not being installed, to
ensure proper airflow and cooling.
3. Attach one end of the ESD wrist strap packaged with the SmartSwitch 9000
chassis to your wrist. Plug the other end into the ESD Wrist Strap Grounding
receptacle in the lower right corner of the SmartSwitch 9000 Chassis shown in
Figure 2-3.
4. Slide the module into the slot and lock down both the top and bottom plastic
tabs, as shown in Figure 2-3. Take care that the module slides in straight and
engages the backplane connectors properly. When installing the module,
ensure that both circuit cards are between the card guides, as shown in
Figure 2-3. Check both the upper and lower tracks of both cards.
The INB Terminator Modules must be installed on the rear of the chassis before
powering up this module. Refer to the INB Terminator Modules Installation
Guide
for information and installation procedure.
NOTE