11
D
EVICE
O
PERATION
Hub-Switch Function:
When the Hub-Switch mode is active, the KVM will tie the PC,
built-in USB hub, and audio together allowing them to switch
simultaneously. Using this method, the USB Hub and audio
always switch to the active PC.
This is required in order to
use a USB keyboard and mouse.
The Hub-Switch can be activated by pressing and holding any
of the PC Buttons on the front of the KVM for 4 seconds.
If you are using a PS/2 keyboard, then you may activate the
Hub-Switch by Hot Key, [Scroll Lock] + [Scroll Lock] + [H].
When active, the green LED on the front of the KVM will follow
the red LED that indicates the active computer
When Hub-Switch mode is off you must switch the hub to the
new target host by hotkey.
When active, you can turn off the Hub-Switch mode by
pressing and holding any of the PC buttons on the front of the
KVM for 4 seconds. You can also turn off the hub-switch by
Hot Key, [Scroll Lock] + [Scroll Lock] + [H].
When the hub-switch is not active, the green LED on the front
of the KVM will not follow the red LED when switching
between computers..
Auto-Scan Function:
When you enable Auto-Scan mode the KVM will cycle through
all the ports and display them on the monitor. Each port is
displayed for a time interval before switching to the next
computer. You can adjust the time interval by pressing the
number keys 1, 2, 3, or 4 (Please refer to the hotkey table on
page 10).
Note:
The mouse and keyboard will be disabled in Auto-Scan
mode. This is necessary to prevent errors such as erratic
movement and wrong character display when using the
mouse or keyboard accidentally.
The Auto-Scan mode can be stopped by two different
methods.
Pressing the space bar will turn off Auto-Scan and leave the
KVM’s focus on the computer currently being displayed.
Pressing any other key on the keyboard will stop the Auto-
Scan and the KVM will switch to the PC that was active when
the Auto-Scan was initiated.
F
ONCTIONNEMENT DU PERIPHERIQUE
F
UNCIONAMIENTO DEL DISPOSITIVO
