MP800 UHD Media Player Manual
Page
30
of
45
Rev. 100- 10/17/16
4.2.3. UpdateTNETXapp
description
This command will update the legacy TNET X-App if necessary. See section of Legacy
X-App Support for more information.
command:
UpdateTNETXapp,<TNET xapp file>
<xapp file>= name of the TNET X-App install file, must reside in MP7XXConfig folder.
example
UpdateTNETXapp, smartplplayer_v112.tgz
4.2.4. UpdateXappManager
description
This command will update the X-App Manager itself.
command:
UpdateXappManager,<xapp manager install file>
<xapp file>= name of the X-App Manager installer file, must reside in MP7XXConfig folder.
example
UpdateXappManager,XappManager_v107.tar
5. General Operation
5.1. SD Card and USB Flash Drive Auto Detection
The X-App Manager auto detects insertion of the SD card or USB flash drive.
If the inserted SD Card or USB flash drive contains the MP7XXConfig folder and a mp7xxx.conf file, then the required
commands and configuration settings will be applied and playback will be begin If these items are not detected, then the
player will operate as commanded by the SNMP command set. Refer to the CE Labs MIB Specification for SNMP command
information.
If the SD card or USB flash drive is removed, playback started from that device may be stopped (depends on current playback
conditions and caching of current media files). When the SD card or USB flash drive is re-inserted, playback will be restarted
regardless of current playback conditions.
Note: A USB flash drive will take precedence over an SD card.
5.2. Player Startup
On player start up the operation is as follows:
The player checks the USB flash drive for the MP7XXConfig/mp7xx.conf file. If found, then the player will begin
playback and configuring itself based on command in that file.
If not found, the player then checks the SD card for the MP7XXConfig/mp7xxx.conf file.
If USB flash drive exists on player start up and a valid MP7XXConfig folder and mp7xxx.conf exists then any
commands or configuration items on the USB flash drive will take precedence over the SD Card and the SD Card
items will be ignored.
Note: This startup procedure is also followed when a SD or USB device is inserted into the player. Therefore, device
insertion is likely to cause new content to play or possibly restart the current content depending on whether or not the
inserted device contains the mp7xx.conf file and is the priority device.
5.3. Legacy or TNET X-APP
If a TNET X-App has been loaded to the player, The X-App manager will start this application before attempting to read the
mp7xxx.conf. Generally, the mp7xxx.conf should not be placed on players running a TNET X-App. The TNET X-App
usually is intended to take full control. If a mp7xxx.conf does exist, the player will attempt to run as commanded, however, it
is very likely to interfere with the TNET X-App operation and vice-versa.
