Item
Description
Qty
A
Face Frame with Door
1
B1 & B2
Front Side Panel
s
(
R
ight &
L
eft)
2
C1 & C2
Rear Side Panel
s
(
R
ight &
L
eft)
2
D
Top &
Bottom
Panels
2
1
E
Back Panel
F
Hardware box
1
C
orner
Bracket
135 degree 4pcs,
Corner Bracket 90 degree 6pcs,
1" screws for back panel 4pcs
►
Instructions:
1.
Place the face frame
(A)
face down on a flat soft working surface to ensure that the face is not scratched or
damaged
(Figure 1)
.
Page 2
1-800-CABINET.
►
Items
Quantity
►
Gene
ral
Instructions:
Thank you for
purchasing
a Cabinets To Go product. You are now the proud owner of a high quality product designed
to face the test of daily
use and guaranteeing your enjoyment for many years to come.
Carefully read the instructions before starting the installation.
During assembly, please follow all generally accepted safety procedures.
Failure to adhere to the following instructions will invalidate the warranty and Cabinets To Go will decline any
responsibility for any
damages caused. Any installation which does not correspond to the instructions may result in
defects, malfunctioning parts, significant
damage and/or injury.
Before the assembly begins, check that all appropriate and required plumbing and electrical connections exist.
Before drilling, make absolutely sure that there are no pipes (gas, water,electricity, heating, etc.) at the drilling
location. Cabinets To Go will
not be held responsible for failure to follow these instructions.
PRIOR TO ASSEMBLY, PLEASE MAKE SURE YOU HAVE ONE FACE FRAME BOX AND ONE CARCASS BOX, WHICH HAVE ALL THE PARTS IN THE
QUANTITIES MENTIONED BELOW. IF YOU ARE MISSING ANY PARTS, PLEASE STOP AND CONTACT CUSTOMER CARE IMMEDIATELY AT
►
Required
tools:
Tools
R
equired:
Phillips S
crewdriver
Optional Tools
:
E
lectric
D
rill
Optional
Tools: Rubber Mallet
►
Hardware Box
:
a
b
c
d
Qty
6
Q
ty
2
0
Qty
4
Q
t
y
8
e
Q
t
y
8
f
Q
t
y
4
Qty
2
g
Figure 1
A
B2
D
C2
B1
C1
E
D
A
round bumpers 2pcs, 1/2" flat head screws 20pcs, drywall anchors 8pcs, 2" flat head screws 8pcs
The materials listing above are for the largest unit in this instruction set. Smaller units may require less hardware and materials;
therefore, your item may contain a smaller number of each.
