CAB XENO 4, Руководство по сборке

Страница: 32 / 51

32 32
4 Software and Programming
4.10.2 Settings "Repeat Process"
This window is used to set the process flow in the cyclic operation mode.
Figure 28 Settings "Repeat process"
Setting Description
FOR OPERATION FROM THE CONSOLE
Starting each cycle via software
Prompt operator between each cycle, and run
indefinitely
Continuous operation
Prompt operator between each cycle, and stop
the process after ... cycle(s)
Operation with defined number of cycles
AUTOMATION ONLY One single start of the job via software
Start of every single cycle via automation control
Do not prompt between cycles, and run
indefinitely
Continuous operation
Do not prompt between cycles, but stop after
... cycle(s)
Operation with defined number of cycles
Save Job after every cycle
Saving jobs with current values of variable fields (counter
or date fields) to be able to continue with updated values
when calling again.
Table 12 Settings "Repeat process"

Select one of the setting under "AUTOMATION ONLY" for the automated operation.