11
4
Settings
4.1
Setting the Lateral Position
i
Note!
The lateral alignment of the applicator is necessary to place the labels exactly on the product using the stop
2
1
3
5
4
6
Figure 8 Setting the lateral position
Loosen the screw (2).
Move the wrapper unit (3) by turning the adjusting knob (1) and align the marker (5) to the liner margin (4).
Tighten the screw (2)
4.2
Setting the Stop
Using the stop results in accurate repeatability of label positioning.
i
Note!
Markings on scale (3) are valid only with applicators set in the correct lateral position
2
1
3
4 5
Figure 9 Setting the stop
Loosen the screw (1).
Set the scale (3) with the stop (4) so that the desired distance from the label margin to the end of the product is
indicated next to the chassis (2).
Tighten the screw (1).
After loosening the screw (5), align the stop (4) for optimum contact with the product.
