10
10
4.2.2
Mode 1b - Starting Print and Confirming Label Removal with
Signal XETE
Figure 4 Jumper at position
JP1
Hold signal
XSTART
permanently active.
For that connect Pin 1 (XSTART) with Pin 15 (P24) and Pin 8 (GND) with
Pin 9 (RXSTART).
Send a print job.
The first label will be printed an transported to the peel position.
Remove the label.
Confirm the label removal with signal
XETE
.
The next cycle will be started.
XSTART
XFEH
XETE
XESP
XEDG
XDNB
XEDST
GND
RXSTART
RXFEH
RXETE
GND
STA
RUEL
P24
Figure 5 External minimal circuit at the peripheral interface for mode 1b
