7
6
2.3
Adjusting the Scanner
1
2
4
3
Figure 2
Adjusting distance and angle
In order to adapt the code checker to the code to be checked the scanner may be adjusted :
i
Notice!
If the device was factory-adjusted the adjustment parameters can be found in the test record.
Adjusting the reading distance
•
Adaptation to size and resolution of the code
Loosen knurled screw (2).
Move the upper part of the retainer (1) with scanner.
Tighten knurled screw (2).
Adjusting the reading angle
•
Adaptation to the position of small codes on the label
Loosen knurled screw (3).
Turn the scanner (4).
Tighten knurled screw (3).
i
Notice!
The moment of checking during the label feed can be set in the software.
Programming Manual.
