13
5
Installation
5.1
Factory Default Settings
i
Note!
The applicator is adjusted in a standard configuration by the factory. Adjustments with these values
guarantee a smooth operation with same configuration.
i
Note!
In case of a customer setup with special material the adjustments can deviate from standard values.
Then the values in the setup protocol are valid.
The standard values for the settings ex-factory are:
-
Connecting on a cab printer, vertical
-
Pressure value of the compressed air
0 45 MPa (4.5 bar)
5.2
Tools
Screwdriver with parallel blade
2.5
To adjust the throttle valves and
product sensor
Hexagon key L-wrench
0.8
To adjust the sensors
(in contents of delivery)
2.5
For matched norm parts
(in contents of delivery)
4
Pad adjustments
Changing pad
Flat-round nose
straight
To mount/dismount tubes
angled
Open spanner
SW 8
To change the throttle valves
SW 13
Setting the spring power on the
adapter bolt
SW20
Changing the cylinder
Manometer
± 7 bar
Air pressure control
Table 3
Tools
