Copyright © 2011 Shenzhen C2S Technology Co., Ltd. All rights reserved.
9.1 Connecting Wires
• Wires should be connected while module is not plugged in.
• Wires should be fastened to the other wires or non-moving parts. Try to avoid heat emitting and
moving objects near the wires.
• The connections should not be seen very clearly. If factory isolation was removed while
connecting wires, it should be applied again.
• If the wires are placed in the exterior or in places where they can be damaged or exposed to heat,
humidity, dirt, etc., additional isolation should be applied.
• Wires cannot be connected to the board computers or control units.
9.2 Connecting Power Source
• Be sure that after the car computer falls asleep, power is still available on chosen wire.
Depending on a car, this may happen in 5 to 30 minutes period.
• When module is connected, be sure to measure voltage again if it did not decrease.
• It is recommended to connect to the main power cable in the fuse box.
9.3 Connecting Ignition Wire
• Be sure to check if it is a real ignition wire – power does not disappear while starting the engine.
• Check if this is not an ACC wire (when key is in the first position, most electronics of the vehicle
are available).
• Check if power is still available when you turn off any of vehicles devices.
• Ignition is connected to the ignition relay output. As alternative, any other relay, which has
power output, when ignition is on may be chosen.
9.4 Connecting Ground Wire
• Ground wire is connected to the vehicle frame or metal parts that are fixed to the frame.
• If the wire is fixed with the bolt, the loop must be connected to the end of the wire.
• For better contact scrub paint from the place where loop is connected.
9.5 Connecting Antennas
• When placing antennas avoid easily reached places.
• Avoid GPS antenna placement under metal surfaces.
• GPS antenna must be placed so its state is as horizontal as possible (if antenna is leant more than
30 degrees, it is considered incorrect mounting).
• GPS antenna cable cannot be bent more than 80 degrees.
• GPS antenna must be placed sticker facing down
