C2R Colibri 5 30-001, Руководство пользователя

Страница: 42 / 168

Colibri serie 5 : User’s guide
© 2000-2008 C2R Technologie, Sarl. All rights reserved.
42 42
Rev. C
Output Sequence Overview
Require Output Sequence
When turned off, the bar code data will be output to the host as the Imager decodes it. When
turned on, all output data must conform to an edited sequence or the Imager will not transmit the
output data to the host device.
Note:
This selection is unavailable when the Multiple Symbols Selection is turned on.
Output Sequence Editor
This programming selection allows you to program the Imager to output data (when scanning
more than one symbol) in whatever order your application requires, regardless of the order in
which the bar codes are scanned. Reading the
Default Sequence symbol programs the Imager
to the Universal values, shown below. These are the defaults. Be certain you want to delete or
clear all formats before you read the Default Sequence symbol.
Note: To make Output Sequence Editor selections, you‟ll need to know the code I.D., code
length, and character match(es) your application requires. Use the Alphanumeric symbols (inside
back cover) to read these options.
Note:
You must hold the trigger while reading each bar code in the sequence.
To Add an Output Sequence
1. Scan the Enter Sequence symbol (see Require Output Sequence, page 44).
2.
Code I.D. On the Symbology Chart on page 155, find the symbology to which you want to
apply the output sequence format. Locate the Hex value for that symbology and scan the
2 digit hex value from the Programming Chart (inside back cover).
3.
Length Specify what length (up to 9999 characters) of data output will be acceptable for
this symbology. Scan the four digit data length from the Programming Chart. (Note: 50
characters is entered as 0050. 9999 is a universal number, indicating all lengths.) When
calculating the length, you must count any programmed prefixes, suffixes, or formatted
characters as part of the length (unless using 9999).
4.
Character Match Sequences On the ASCII Conversion Chart (Code Page 1252), page
157, find the Hex value that represents the character(s) you want to match. Use the
Programming Chart to read the alphanumeric combination that represents the ASCII
characters. (99 is the Universal number, indicating all characters.)
5. End Output Sequence Editor Scan F F to enter an Output Sequence for an additional
symbology, or Save to save your entries
Other Programming Selections
•
Discard
This exits without saving any Output Sequence changes.
Output Sequence Example
In this example, you are scanning Code 93, Code 128, and Code 39 bar codes, but you want the
imager to output Code 39 1st, Code 128 2nd, and Code 93 3rd, as shown below.
Note: Code 93 must be enabled to use this example.