Flashing Red
: low battery condition.
Amber:
string is in-tune.
Green:
amp on in double coil mode, or string is too sharp in tune
Red:
amp on in single coil mode or, string is too flat in tune mode.
Three colored LED light indicates that unit is on and operating. Led
changes color from red, green and yellow depending on what effect or
function is engaged.
amp on/off
Amp button turns unit on and toggles between two pre-amp settings.
Amp-1 is setup to work best with single coil pickups and is indicated with
LED. Amp-2 is optimized for double coil pickups and is indicated
with
LED. The unit can be turned off by holding down Amp button
for 3 seconds.
red
green
led
reverb:
Button selects between three (3) distinct clean tube amp tones. Each
tone has a natural, not overly compressed sound, rich in harmonic
content and dynamic range.
Button selects between three (3) distinct tube style distortion tones.
Position one has a Fender-like crunch. Position two has the classic
Marshall overdrive sound, and position three is a highly compressed
heavy metal overdrive tone. Each tone is natural, with, rich harmonic
content and wide dynamic range.
delay:
clean:
dirty:
Button allows user to select Double, Chorusing, Flange or no delay effect.
Button allows user to select Slapback, Club-Reverb, Hall-Reverb or no
reverb effect.
The V2 is designed to operate with a 9-volt Alkaline battery, or a
C-Tech NiMh (8.4v nominal) rechargeable battery. Battery life
will vary depending on usage, but a high quality Alkaline battery
should last between 10 and 15 hours with continuous use.
The battery should be disconnected when the V2 will not be
used for a prolong period of time.
Also, since b
will
also protect the V2 from battery leakage and subsequent
damage to the unit.
When the battery in the V2 begins to run down, the unit may
turn off unexpectedly. This
will be
indicated with a flashing red LED. At this point, your battery
should be replaced or recharged. If the battery light does not
come on at all, then the battery has deteriorated to a point,
where the low battery alert circuit is not working.
Again,
change or recharge your battery.
The V2 also has an
feature. This feature
conserves battery life by automatically turning the V2 off
whenever the unit has been idle for more than three (3)
minutes.
This feature is particularly important in situations
where the user forgets to turn the unit off, or if the units is
accidently turned on.
atteries
discharge over time even when not in use, removing the battery
from the unit will extend battery life. Removing the battery
low battery condition
Auto Shutdown
Battery Management:
