Instruction Booklet
9-Series
ITEM DESCRIPTIONS
Display I for
Routine
Maintenance
Display II for
Routine
Maintenance
The initial mileage of routine maintenance is 5000km
Display :
When it reaches the mileage for routine maintenance,
ODO symbol will start to flash for 1 minute.
Time to display :
1.when the ODO reaches the mileage for routine
maintenance during driving
2.when the ODO reaches the mileage for routine
maintenance during Key On
Flashing
PS.During flashing, the mobility vehicle could be drove
normally and the control penal could be operated
without any delay.
After the routine maintenance is finished, the user could
setup the mileage for next maintenance.
(Count down setting)
Setup steps:
1.Press
「
Mode
」
button and switch to ODO mode
2.Key off to shut down the controller
3.Press
「
Mode
」
and
「
H/L
」
buttons together
4.Key on to start the controller
5.The display will enter setup mode in 2 secs, the
mileage will be flashing. (as Note 1)
6.Press or button to adjust to the mileage for
next maintenance (as Note 2)
7.After setup is finished, press any button of Parking
light, Horn, Turn signal or Headlight, the definitive settings
will be stored and return to normal working mode.
8.The display will quit to normal working mode while
the user does not press or button in 10 secs.
3.Notice to Routine Maintenance for certain mileage
21
The user could quit the setup mode with the following
conditions.
(1) Leave
「
Mode
」
button alone for 15secs.
(2) Press any button of Parking light, Horn, Turn signal or
Headlight, the definitive settings will be stored and
return to normal TRIP mode.
Quit Setup Mode
L
F
E
AM
SPD
TRIP
ODO
