Instruction Booklet
8-Series
6
FUNCTION OF PARTS
：
TOP CONTROL PANEL
•
Speed Dial Knob
The Rabbit means fast and Turtle is slow. By turning this you control total speed
transferred to thumb controls.
•
Battery Gauge
There is a meter shows batteries capacity status.
ADJACENT TO TOP CONTROL PANEL
•
Thumb Lever
Pushing right thumb lever moves scooter forward. Pushing left thumb lever moves the
scooter backward. (This can be reversed if required by local dealer.) Releasing both,
engages automatic brake. These are also your accelerator. The further you depress
them, the faster you go. (Subject to the position of the Rabbit/Turtle control).
AT BASE OF STEERING TILLER
•
Tiller Angle Adjustment
Pull downward the tiller adjustment to adjust tiller angle and release to lock at
comfortable position.
BELOW SEAT
•
Seat Height Adjuster
There are three holes on seat tube to adjust seat height. Be sure the detent pin is fully
inserted at its new height before sitting.
•
Armrest width Adjustment Thumbscrews
Loosen the two thumbscrews to adjust arm width; tighten again to lock in at desired
position.
•
Legroom Adjuster
There are few holes on front and rear frame tube for adjusting legroom. Pull the toggle
latch to loosen and insert the detent pin to locate the position. Push the toggle latch
again to lock.
REAR BODY
•
Rear Compartment Cover
Open the compartment Cover to access on board charger.
•
Anti-tip wheels
Helps keep scooter from tipping over.
•
Free-Wheeling Lever
When lever is in N (Neutral) position, scooter can be moved without power.
When lever is in D (Drive) position, scooter can be driven. Normal position is D.
