![background image](http://html.mh-extra.com/html/c-scope/cs6mx/cs6mx_operating-instructions-manual_478480007.webp)
Belt mounting
Squeeze the control box retaining clips together using your thumbs as shown in the
photograph. The control box will now slide towards you free of the control box mounting
clip. The control box can be fitted to your belt using the clip provided. In belt mounted
use, be sure to wind the search-head cable up the stem at least to the stem lock and
secure it with tape or cable tie. This is because the lead will be detected like a target if it
is left free to move.
Undo the 4 battery compartment retaining screws and take out the battery holder.
Fit eight good quality AA type batteries into the compartments of the battery holder.
Observe polarity of the batteries (the spring contact goes against the flat, negative end
of the battery). Roll the batteries in the holder to ensure good contact and replace into
the battery compartment with the contacts on the holder lining up with the contacts in
the compartment. Replace the battery compartment cover being careful to avoid cross
threading the screws. Battery condition is monitored continuously on the CS6MX. Low
batteries are indicated by a warble alarm repeated every few seconds.
Batteries
Above: Slide the belt mounting clip into the fixing slots on the underside of the control box and
push all the way until the retaining lugs click into position.
CS
6MX
7
Содержание CS6MX
Страница 1: ...CS6MX Operating Instructions ...