8
PAGE DEFINITION AND APPLICATION
1.
CONNECT/Disconnect: Click to connect or exit the network connection
,
the network signal strength
value (1-26) can be seen after the successful network registration
.
2.
OUTPUT1/OUTPUT 2
:
Activate relay 1 and relay 2 respectively, select to activate the relay and unselect
to deactivate the relay. (Output 1 only on this version).
3.
REFRESH: Select this button to refresh the page.
4.
Firmware Build: Apr 1 2021 16:59:58 - firmware creation time
5.
Host Status, Ready working: Working properly.
Parameters
6.
Administrator password: 4 digits (default 1234)
7.
Administrator SMS confirmation
:
After the selection, the administrator will receive a confirmation
message after each operation.
8.
Auto test SMS (hours): This function is used to check whether the device is working normally at regular
intervals. The user can set it so that every 1
–
720 hours the controller will automatically send a test
message to the user's mobile phone to confirm that the device is working normally. This is also useful
for keeping PAYG SIM cards active. 0 = no test message sent.
9.
Authorised users only: control can be performed only from authorised number in the device (default)
or from any phone number without limitations (unselect)
10.
Save: save settings
11.
Restore factory: The numbers, working mode and password are all restored to factory default
12.2 Call
Setup what happens when the unit is called.
Work mode: The unit can have two types of working mode:
1.
MODE A: NON LOCK. Mode A is the factory default function and allows the caller to activate the relay
from 1 second up to 65,000 seconds.
a)
OUT1 working time (sec): Enter the time you want the relay to switch for when the unit is called
2.
MODE B: SELF LOCK. Mode B allows the caller to activate the relay on & off (toggle) with alternate
phone calls.
Please note MODE C & D do not apply to this version.
OUT1 SMS confirmation: In both modes you can choose whether or not you want to receive SMS
confirmations whenever the relay is activated or deactivated.
Click
SAVE
to save settings.
