If the new master code entered for the second time is not the same as the first, the led will issue a
series of red flashing lights and the new master code will not be programmed.
New access code:
Press the
✳
✳
✳
✳
key for 3 seconds until the led issues a slow red flashing light. Enter the master code
and press OK. The led will issue a faster red flashing light. Enter the new code (from 1 to 8
numbers) followed by the channel (from 1 to 4) and press
OK
. The led will issue a permanent
green light for 2 seconds to indicate that the new access code has been correctly programmed
before switching off.
The same code cannot be used on more than one channel. If a new code is programmed in an
already programmed channel, this will replace the previous code.
Registering with the receiver:
Enter programming mode in the receiver, enter the access code and then press the OK key. The
receiver will issue a confirmation beep. Wait until the receiver exits programming, signified by two
beeps. The keypad will now be operational.
Operation
Enter the memorised code and press OK. The led will issue a green light for 2 seconds. If the code
is incorrect, the led will issue a series of red flashing lights.
If, while entering the code, a key is pressed by mistake, press the OK key or wait 20 seconds before
re-entering the code.
The keypad goes to battery saving mode after 20 seconds if no key is pressed.
Low battery indicator
On receiving confirmation after entering a code, the led will issue a series of green flashing lights
for 1 second. This indicates that the battery is low. It should then be changed.