USER MANUAL
- ENG -
www.cpa-piscine.it
pag. 28
Ver.00
–
AQ10MC-R32
–
2019-05-07
D. Installation guidance
1. Installation reminder
Only a professional staff is allowed to install the heat pump. The users are not qualified to install by themselves,
otherwise the heat pump might be damaged and risky for users’ safety.
a. Location and water pipe connection
The inverter pool heat pump should be installed in a good ventilation place.
1.
The frame must be fixed by bolts (M10) to concrete foundation or brackets. The concrete foundation must
be solid and fastened; the bracket must be strong enough and antirust treated;
2.
Please don’t stack substances that will block air flow near inlet or outlet area, and the
re is no barrier within
50cm behind the main machine, or the efficiency of the heater will be reduced or even stopped;
3.
The machine needs an appended pump (Supplied by the user). The recommended pump specification-flux:
refer to Technical Parameter, Max. li
ft ≥10m;
4.
When the machine is running, there will be condensation water discharged from the bottom, please pay
attention to it. Please hold the drainage nozzle (accessory) into the hole and clip it well, and then connect a
pipe to drain the condensation water out.
5.
The i
nlet and outlet water unions can’t stand the weight of soft pipes.
The heat pump must be connected
with hard pipes!
