WHITE POOL INSTRUCTION MANUAL
pag. 14 / 29
www.cpa-piscine.it
Rev.00
–
16/10/20
WHITE POOL 910 - 8011014
Place the 1st assembled frame upright across the width of the pool at a point 3070 mm from the end of the cleared area.
Place the 2nd and the remaining assembled frames at a point 1480 mm from the center line of the adjacent assembled frame (see
diagram 14).
Note:
1480 mm measurements are taken from the center of the L supports.
Diagram 14
To check the alignment of the assembled frames, position string line along the back of the assembled frames (the back of the L
support) about 200 mm above the ground between two steel pegs, position A and B as shown in diagram 15. If the L Supports are
not correctly aligned, they need to be tapped back or forward until the back of each L Support is correctly aligned with the string
line.
Diagram 15
Once the steps have been completed you need to check the diagonal measurements of the pool frame. Measure the two intersecting
axes to ensure that the two straight sections are parallel. The measurements of the points A to D and B to C must be equal (see
diagram 16).
Diagram 16
picchetto
picchetto