background image

Document:  

Date

Created By: 

 

 

LPN00703X0001A0_A 

  08-16-2021

TMT 

  

INSTALLATION INSTRUCTIONS

C-WP-A-TWP Series

http://lighting.cree.com/warranty      |     866.924.3645     

CAUTIONS

NOTE: 

Knockouts are provided for mounting over a 4" octagonal 

junction box.

1.  Remove lens assembly by loosening screws on side of frame. 

Swing lens assembly open, disconnect quick-connect wiring 

connector, and slide lens assembly on hinges to remove from 

mounting box. See 

Figure 1.

2.  Remove center plug from mounting box. See 

Figure 2.

3.  Drill out appropriate knockouts for chosen junction box. See 

Figure 3. 

NOTE:

 Fixture should not be exclusively supported by junction 

box. Drill through appropriate knockouts in four corners of housing 

for additional support. See 

Figure 4.

4.  Pull supply leads from junction box through center hole in 

mounting box. Attach mounting box to mounting surface at junction 

box and in four corners. Customer supplied hardware appropriate 

for the mounting surface should be used. 

NOTE: 

A high grade caulking material, such as silicone rubber, 

should be used between the four gaskets in the corners and the 

mounting surface and around perimeter of the junction box gasket 

to prevent water entry into the fixture or junction box.

5.  Use switch inside mounting box to set desired color temperature. 

See 

Figure 5.

 

NOTE:

 Power must always be OFF when adjusting color 

temperature.

6. 

Rotate knob to select desired wattage for fixture. See 

Figure 6.

 

NOTE:

 Power must always be OFF when adjusting wattage.

7.  Make wiring connections per the Electrical Connections section.

8.  Replace the lens assembly on hinges, re-connect quick-connect 

wiring connectors, and swing lens into place. Retighten screws 

that were loosened in Step 1 above.

MOUNTING OVER RECESSED JUNCTION BOX

FIGURE 1

FIGURE 2

FIGURE 3

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety 

precautions should always be followed including the 

following:

READ AND FOLLOW ALL 

SAFETY INSTRUCTIONS

1.  DANGER

- Risk of shock- Disconnect power before 

installation.

DANGER

 – Risque de choc – Couper l’alimentation 

avant l’installation.

2.  This luminaire must be installed in accordance with the 

NEC or your local electrical code. If you are not familiar 

with these codes and requirements, consult a qualified 

electrician. 

Ce produit doit être installé conformément à NEC ou votre 

code électrique local. Si vous n’êtes pas familier avec ces 

codes et ces exigences, veuillez contacter un électricien 

qualifié.

3.  Suitable for Wet Locations.

 

Adspte pour les Endroits Mouiles.

4.  Min. 90

°

C supply conductors. 

Les fils d’alimentation 90

°

C min.

5.  WALL MOUNT ONLY. 

INSTALLATION MURALE SEULEMENT.

SAVE THESE INSTRUCTIONS 

FOR FUTURE REFERENCE 

Mounting Box

Отзывы: