C.E.C. DA3N, Руководство пользователя

Страница: 9 / 24

DA3N User's Manual
9
the sampling frequency is displayed.
Note: Due to the input signal quality DA3N sometimes can not lock the
signal properly resulting in having a noise in the music. In that case select
the input again to reset the locking.
Note: Whenever changing the input to or from the SUPERLINK the
master clock source is also switched to external or internal to cause the
CD Transport to stop the playback. Push the CD play button again to
resume the playback.
When changing the input, set the volume to lower level to avoid
speaker damage! Each input signal varies the sound level and it
might amplify the small noise to the big one.
❺
DISPLAY
Ⓐ
The selected digital input is displayed.
Ⓑ The selected input sampling frequency is displayed.
When no or incompatible signal is there "Unlock" or "Unknown"(at USB)
is displayed.
When the volume knob is turned the level is displayed for 6 seconds.
Ⓒ The selected digital filter type is displayed.
"P" is displayed when "PULSE" is selected or "F" for "FLAT". You may
change the digital filter by remote control. Refer to page 10 about the
digital filter function.
Ⓓ An external master clock input is displayed.
"M" is displayed when a SUPERLINK is selected and an external master
clock 44.1kHz is connected. The same external master clock is supplied
to the CD Transport via DA3N.
❻
REMOTE Sensor
The remote sensor, which receives signals from the remote control unit, is
located at the right side of display. Address the remote control unit to the
sensor correctly. The remote control unit may malfunction if there should
be any obstacles between the remote control unit and the remote sensor.
❼
VOLUME Knob
The volume at headphone output and Variable output level can be
Ⓐ Ⓑ Ⓒ
Ⓓ
Ⓐ Ⓑ Ⓒ
Ⓓ