C. Crane CCRadio 2E, Инструкция по эксплуатации

Страница: 21 / 34

Page 21
CCRadio2E
LINE OUT JACK
The red jack, labeled LINE OUT, is used to output the audio from the
CCRadio2E to another device such as a recorder, your home stereo, or
some other unit. To do this, you will need an (1/8” (3.5mm) stereo) patch
cord.
NOTE: The LINE OUT jack differs from a headphone jack because the
volume level of a headphone jack varies depending on the volume of the
radio. The LINE OUT jack has a set line level so the volume is con sistent
no matter what the position of the volume knob.
1) Plug your patch cord into the LINE OUT jack on the CCRadio2E.
2) Plug the other end of the patch cord into the LINE IN or AUDIO IN
of the device you want to send the audio to and you will hear the radio
through the other source. You can still listen to the CCRadio2E while
using the LINE OUT jack.
TIMER ACTIVATION SWITCH
The black jack labeled with this symbol is for use with a recorder that
has a timer activated switch. You would use this switch if you want ed to do
a timed recording. It is used in conjunction with the LINE OUT jack. See
your recorder’s instructions to determine if this function will work with your
recorder.
SETTING THE TIMER
Please read this entire section carefully before you start.
You must go
through the 3 steps listed below without stopping. If you stop for more than
15 seconds, press and hold the Timer Button until you hear a single beep.
Then start at step one again.
Before you begin, program the stations that you will want to record into
memory. Refer to page 14 for instructions on programming memory
pre sets. The timer has an ON TIME and an OFF TIME. You must set
both in order for the timer to work correctly.
STEP 1: TO SET THE ON TIME
1) Press and hold the Timer/Set Button until you hear a beep and see the
word ON, the hour digit and TIMER flash on the display.
2) Use the Tuning Up/Down Buttons to set the hour, verifying that the time
is set correctly for AM or PM as shown on the display.
3) Press the Timer/Set Button again so the minutes and the word ON and
TIMER flash on the display.
4) Use the Tuning Up/Down Buttons to set the minutes.
Radio Operation