Copyright 2017 © C. B. Gitty Crafter Supply 5
jacks. The red connectors (attached to the red wires) should be pushed onto the positive jack lugs, and the
blue connectors (attached to the black wires) should be connected to the negative/ground jack lugs. See the
photo above for a visual reference.
If the press-fit connectors seem a little loose on the jack lugs, use some pliers to gently squeeze them to
make a tighter fit. If you are comfortable with soldering, you can of course remove the crimp connectors and
solder the leads directly to the jack lugs, for a more permanent and professional connection.
Do this for both sets of leads/jacks, to end up with what’s shown in the photo below.
Step
3
—Mounting the Circuit Board & Knob
Remove the nut and washer from the shaft of the control potentiometer on the circuit board. Then push the
