4.0 USER OPTIONS
4.1 CHANGING ZONES ON CHIME
"CHIME" is a facility to make particular zones chime when triggered. For
example, you could have a front door chime when opened or a room with
valuables in chime when entered. Chime is only active when the panel is
UNSET. To configure any zones to chime you must first have chime enabled
in the extended options (this needs to be set up by the installer on
installation). If it is enabled press the * key.
The display will show any zones currently set to chime. Press the key number
of the zone you wish to enable/disable. If the control panel does not have the
chime option programmed an error tone will be given. Press the * key to
finish.
4.2 AUTO TEST
( Should be performed at least once a month )
Enter your four digit user code, the buzzer will emit a steady sound and the
exit time will start. Press the * key followed by the 9 key. The exit buzzer will
stop and all the LEDs will light. After the 10 seconds all the LED's will
extinguish and the panel will then test the internal sounder, bell and strobe.
Each will operate for 5 seconds then the control panel will then emit an accept
tone and revert to the 'DAY' mode. You may end the test at any time by
pressing the "*" key.
4.3 CHANGING THE USER CODE
There are two separate user codes available to the customer. A main
MASTER code and a secondary user code which can be enabled or disabled
by the user. By default the second user code will be disabled.
1) Master user 2) Second user
There are no differences to the usage of these codes. They both perform the
same tasks and neither has an advantage over the other. The second code
can be used for example when neighbours are looking after the premises and
you don't want to give them your code, you can simply enable the second
code for them and then when you return from your holiday disable that code
again. This means they no longer have access via that code.
To change a user code simply enter the four digit user code, the buzzer will
emit a steady sound and the exit time will start. Press the * key followed by
the 9 key, followed by the key of the user to be altered for example if you were
changing user code 1 then you would press 1, the same applies for user code
2. Once you have pressed a user key then the LEDs 1 2 3 and 4 will now
come on to indicate a new 4 digit code is required. Enter your new code. As
you press each key one LED will go out.
This manual is from
http://groups.msn.com/UKSecurityPanels
Technical Manuals Online! - http://www.tech-man.com
