BZB Gear BG-LVPTZ-30XHSP, Руководство пользователя, Страница: 31 / 41

28
Network interface enable: can check,to set the following items after checked.
DHCP: can check,if check,it can obtain IP automatically.
IP address:set wirelss WIFI IP(default 192.168.1.250,if checked DHCP,IP could assigned
automatically)
Note: wireless IP address can not be in the same segment with wired IP address.
Subnet Mask: Set the wireless IP subnet mask (default255.255.255.0)
Default Gateway: Set the wireless IP default gateway (default 192.168.1.1)
SSID: The user can modify their own (the default test)
Encryption: can check,the password can be set after checked.
Password: can set password,password can be changed if only checked encryption.
Click on the "Save" button to display "Parameter saved successfully" message,set to take effect
Note: SSID and password should be filled in correctly, otherwise, if restarted after the powered off, the wireless WiFi connection is
not successful.
2)WiFi hot link
Click on the “search” button to search the WIFI hotspot.
Double-click the dialog box after searched user WIFI hotspot,and then input password to connect WIFI. It connected successfully
after shown “successful connect” window.
3)Wireless WiFi login page
If you do not check the above configuration DHCP (automatically obtain IP),then open the browser,enter the wireless network IP
address in the address bar (default 192.168.1.250),press Enter to log construction;If you checked DHCP,then you obtain IP
automatically,just login specific router or switch user interface settings to view the allocation of IP address.
5. Serial Communication Control
Under common working condition, the camera could be controlled through RS232/RS485 interface(VISCA),RS232C
serial parameter are as follows:
Baud rate: 2400/4800/9600/115200 bits / sec; Start bit: 1; data bits: 8; Stop bit: 1; Parity: None.
After power on,the camera first go left,then back to the middle position.Self-test is finished after the zoom moved to the farthest and
then back to the nearest position. If the camera saved 0 preset before,it will be back to that position after initialization.At this
point,the user can control the camera by the serial commands.
5.1 VISCA protocol list
5.1.1 Camera return command
Ack/Completion Message
Command packet Note
ACK z0 41 FF Returned when the command is accepted.
Completion z0 51 FF Returned when the command has been executed.
z = camera address + 8
Error Messages
Command packet Note
Syntax Error z0 60 02 FF
Returned when the command format is different or when a
command with illegal command parameters is accepted
Command Not Executable z0 61 41 FF
Returned when a command cannot be executed due to current
conditions. For example, when commands controlling the focus
manually are received during auto focus.
5.1.2 Camera control command
Command Function Command packet Note