3
Installation Guide: Bell Push
Installation Guide: Chime Unit:
Range Guide
User Hints:
In case of the door chime does not sound, please check the followings:
a) Flat batteries in either Push Button or Door Chime.
b) Wrong battery polarity in either Push Button or Door Chime.
c) For Plug-in Door Chimes make sure the socket is switched on.
d) Bell Push and Door Chime are not paired together, see setup
guide.
e) Materials in between the Bell Push & Chime will reduce the
operating range, move the Door Chime closer to the Bell Push
f) Wire free devices can be affected by external sources e.g. wire
free home alarms or power transformers/adapter
Plug-through Door Chime: BY103
Power: 220 - 240V 50Hz
Range: 100 Metres
Max Load: 1000W
Indoor Use Only
Bell Push: BY30
Power: 1 x CR2032 3V DC Battery
(Included)
IP44 Weather Resistant
Specification
433.92MHz
R&TTE
APPROVED
CH Byron Electrical United Kingdom. www.chbyron.com
A
B
DK
FIN
F
D
GR
LT
IRL
I
L
NL
P
E
S
UK
BG
CZ
EST
H
IS
LV
M
N
SK
SLO
CH
PL
RO
Project Manager
Mr G Hunter
GB: CH Byron
Byron House,
Sherwood Rd
Astonfields,
Bromsgrove
B60 3DR. UK
9-5 Mon-Fri, Local call harges apply
Tel: 0845 2301231 (UK)
www.chbyron.com
M
N
SK
SLO
CH
PL
RO
V1.0
Place the door Chime within the operating range, transmission
of the wire free signal through
Walls, Doors and Ceilings etc, may reduce the operating range.
Chime unit for INDOOR use only.
Diagram for illustration purposes only
2
‘CLICK’
1: Using back plate as a
template
2: Making sure UP arrows
points UP.
2: Mark and drill holes.
3: Insert wall plugs and attach
to wall using screws
provided.
4: Clip the Bell Push on to the
back plate making sure the
Bell Push ‘Clicks’ in to
place.
Note: The Bell Push can be
installed using a suitable double
sided adhesive tab or tape when
drilling is not sutiable.
Installation Guide:
Avoid locating the Bell Push/Chime on or directly near
metallic surfaces as this may reduce the operation range.
UPVC Door Frames:
When locating the bell push onto a UPVC door, always check
the operating performance before final
installation, internal metal frame may affect performance.
Note: Try adjusting the location of the Bell Push to the Left/Right or place
on external wall.
1
Changing Batteries:
Bell Push:
1: Remove back plate from the
Bell Push.
2: Remove old battery from the
holder.
3: Replace with new ‘CR2032’ 3V
battery.
4: Insert into holder making sure
‘+’ is facing up.
5: Test Chime Kit.
Always dispose of old batteries in an environmentally friendly way.
Type R2 Device - device where the sound output is created by the initial
operation of the control and where the period of sound output continues for
the designed duration irrespective of condition of the control.
IMPORTANT:
There are no serviceable parts, do not repair. The appliance is not to be used by children or persons with
reduced physical, sensory or mental capabilities, or lack of experience and knowledge,unless they have been
given supervision or instruction. Children should be supervised to ensure that they do not play with the
appliance.
