Finishing Touches
Install the transistors. Do not solder the transistors. Simply push the lead wires into the
appropriate socket holes. The lead wires on the germanium transistors will be rather
longs, so you will want to clip off the excess. But be sure to leave enough so you can
bend the transistor down and out of the way when you seal the enclosure. Some brands
will only have a dot (could be any color) to denote the collector. Some brands will have a
tab to denote the emitter. Some brands could have both indicators. Some brands may
have neither. In this case they will positions the lead wires in a triangular formation that is
offset from the center ( see bottom view).
If you were holding out to bare bus wire the sleeves of the jacks don't forget to do that.
Install the base of the enclosure with the 4 screws that came with your kit. Add the rubber
bumper feet...unless you're a velcro person. If you've got any problems that you can't
figure out yourself, visit
board.buildyourownclone.com
for technical support
Содержание Ultimate Fuzz Kit
Страница 9: ......
