
wet signal level. Increase the value to reduce signal level. Reduce the value to increase
signal level.
4.
Adjusting the DRY SIGNAL level
- The 33k resistor highlighted in red controls the
dry signal level. Increase the value to reduce signal level. Reduce the value to increase
signal level.
5.
Adjusting the REGENERATION SENSITIVITY
- The 47k resistor highlighted in
red limits the feedback level. Increase the value to reduce signal level. Reduce the value
to increase signal level.
6.
Adjusting the OVERALL VOLUME level
- The 27k resistor highlighted in red
controls the overall volume level. Increase the value to reduce signal level. Reduce the
value to increase signal level.
7.
Adjusting the DIFFERENTIAL VOLUME level
- There will be a slight volume
boost and the regeneration control will become more sensitive when in differential mode.
You can adjust the level of BBD line B by changing the value of the 22k resistor
highlighted in pink.
8.
MODIFYING FOR BASS
- Bass modulation FX typically differ from guitar
modulation FX in two ways. 1. They usually have less wet signal and more dry signal. 2.
The wet signal is usually filtered so that it affects more of the high frequencies and less of
the low frequencies. So to modify your flanger for bass, you would want to follow the
mods already described above and 1. reduce wet signal, 2. increase dry signal, 3. adjust
the high pass filters to let less bass through (try a .01uf/10n cap), and 4. adjust the overall
volume level if need be.
9.
DUAL PITCH CHORUSING
- Because the BYOC flanger is using two independant
BBDs in parallel, it is possible to use a mismatched set of BBDs so that you get a second
wet signal that is at a slightly different pitch than the first. If you put an MN3208 (normal
DIP8 package not Special DIL8 package, i.e., V3208 or BL3208a) in the BBD B
position, you can add a slightly lower pitch to the chorusing because it has a longer delay
time than the MN3207. This gives the pedal a much lusher and swirly tone, but may be a
little too over the top with distortion.
Содержание Stereo Analog Flanger
Страница 9: ...Step 3 Add the 4 x 2 pin header socket...
Страница 21: ...Step 2 Connect the pre stripped and tinned wires to the 1 4 jacks...
Страница 25: ...Installing the IC...