BYOC Parametric Multi-Band Compressor, Инструкция по эксплуатации

Страница: 25 / 31

•
Cut a two 2” piece of wire. Strip 1/8” off each end and tin.
•
Strip ¾ ” off the other end and very carefully tin. You do not want too
much solder on this end.
•
Thread the longer stripped end into LUG4 and through to LUG9.
•
Solder both lugs 4 and 9.
•
This step can be tricky. If it is too difficult or frustrating for you, you
can simply insert two pieces of wire into LUG4 and solder. Then
connect the other end of one of the wires to LUG9. It won’t look as
pretty, but it will accomplish the exact same thing.
Step 4: Install the foot switch into the enclosure if it isn’t already. Insert
the foot switch wires into their respective eyelets on the PCB. You can
insert them into the top side and solder on the top side as well. The solder
pads should be large enough (if you are using a soldering iron that isn’t too
big) to allow you to do this without burning the PVC coating on the wires if
you are careful. If you do singe the plastic on the wires, it’s OK. It’s not
going to hurt anything. It’s purely aesthetic. See diagram below.