BYOC Envelope Filter, Инструкция по эксплуатации

Страница: 8 / 10

Installing the LED and Mounting the Circuit
Board
1. Insert the LED into its slot on the underside or solder side of the circuit board,but DO
NOT SOLDER it yet. Make sure the anode(the long leg) goes in the round solder pad
and the cathode(the short leg)goes in the square solder
2. Once you have the LED in place, bend the leads a little bit so that it will not fall out
when you turn the PCB over
3. Install the nylon circuit board standoffs into the mounting holes.
4. Remove the paper backings on the standoff to expose the self-adhesive tape.
5. Insert the LED bulb into the LED hole in the enclosure.
6. Secure the Standoffs to the back of the potentiometers.