BYOC E.S.V. Fuzz Germanium, Инструкция по эксплуатации, Страница: 24 / 29

Step 4: Install the foot switch into the enclosure if it isn’t already. Insert
the foot switch wires into their respective eyelets on the PCB. You can
insert them into the top side and solder on the top side as well. The solder
pads should be large enough (if you are using a soldering iron that isn’t too
big) to allow you to do this without burning the PVC coating on the wires if
you are careful. If you do singe the plastic on the wires, it’s OK. It’s not
going to hurt anything. It’s purely aesthetic.
Step 5: Connect the pre stripped and tinned wires to the 1/4” jacks.
NOTE: Wires shown in black & red are merely to indicate ground wires &
positive power wires, respectfully. Your kit provides purple wire; you may
choose to detonate these in a wire color of your choice