BYOC Brown Face Tremolo, Инструкция по эксплуатации

Страница: 17 / 31

17
Step 2: Hold the PCB in one hand so that the component side of the PCB is in the palm
of your hand and the bottom side with the pots, toggle switch and LED is facing up.
Now use your other hand to guide the predrilled enclosure onto the PCB assembly so
that the pots and LED all go into their respective holes. Once the PCB assembly is in
place, secure it by screwing on the washers and nuts for the pots and toggle switch.
Only tighten them with your fingers. You do not want them very tight yet. Be sure to
keep your hand on the PCB so that it does not fall off the PC mounting posts of the
pots and toggle switch.
Step 3: Turn the entire pedal over so that the component side of the PCB if facing up.
Lift the PCB up off the pots and toggle switch about 2mm just to make sure that the
back of the PCB does not short out against that pots. Make sure the PCB is level and
symmetrically seated inside the enclosure.
Step 4: Solder the pots and LEDs. You will solder these parts on the component side
of the PCB. After you have soldered them in place, be sure to tighten up their nuts.