Byan System 800A Series, Инструкция по установке и техническое руководство

Страница: 8 / 30

BYAN SYSTEMS, INC.
Automated Gate and Access Control Products
413 Linden • Lusk, WY 82225 • (800) 223-2926
7
12. CONNECT THE CORD PER THE ELECTRICAL CONNECTION DETAILS.
NOTE: IT IS HELPFUL TO INSTALL A SINGLE GANG WEATHER PROOF BELL BOX
ON THE GATE POST ACROSS FROM THE OPERATOR. THEN WIRE FROM THE
CONTROL BOX CAN BE PULLED TO THIS POINT AND CONNECTED TO THE S.O.
CORD INSIDE THE BELL BOX.
PURGING THE OPERATOR
SOMETIMES DURING SHIPPING, THE “800A/900A” SERIES OPERATOR GETS
TURNED UPSIDE DOWN AND REQUIRES THE VALVE SYSTEM TO BE PURGED
AFTER YOU HAVE COMPLETED THE INSTALLATION. THIS CAN BE NOTICED IF
THE OPERATOR IS JERKING OR RUNS UNEVEN.
TIGHTEN THE BYPASS VALVE WITH THE ALLEN WRENCH AND GIVE THE
OPERATOR A SIGNAL TO RUN. WHILE THE MOTOR IS RUNNING, OPEN AND
CLOSE THE BYPASS VALVE PAUSING BETWEEN OPEN AND CLOSE. DO THIS 10 TO
12 TIMES. THEN REMOVE THE FILL CAP TO EXPEL ANY AIR IN THE OPERATOR.
REPLACE THE OIL FILLER CAP SCREW AND TIGHTEN ONLY SNUG.
ADJUSTING THE OPERATOR
THE PRESSURES ON THE OPERATOR ARE PRESET AT BYAN SYSTEMS PRIOR
TO SHIPMENT. IF THE PRESSURES DO NEED TO BE ADJUSTED, WHETHER
HIGHER OR LOWER, YOU MUST ADJUST BOTH DIRECTIONS THE SAME
NUMBER OF TURNS (i.e. 1/4 TURN, 1/2 TURN ETC.)
THE PRESSURE ADJUSTMENT SCREWS ARE FOUND UNDER THE LOCKING CAP ON
THE TOP OF THE OPERATOR. LOOKING FROM THE REAR TO THE FRONT OF THE
OPERATOR, THE LEFT VALVE IS FOR RETRACTING PRESSURE AND THE RIGHT
VALVE IS FOR EXTENDING PRESSURE. WITH THE MOTOR RUNNING DECREASE
THE PRESSURES EQUALLY UNTIL THE OPERATOR STOPS MOVING IN BOTH
DIRECTIONS. BEGIN INCREASING PRESSURE ON BOTH VALVES WITH THE
MOTOR RUNNING. ADJUST THE PRESSURE TO WHERE YOU HAVE TO
PHYSICALLY STOP THE GATE. AT THIS POINT, EITHER INCREASE THE
RETRACTING PRESSURE
TURN OR DECREASE THE EXTENDING PRESSURE
TURN. RETRACTING HAS TO BE A LITTLE HIGHER.