Byan System 600A, Инструкция по установке и техническое руководство, Страница: 7 / 30

BYAN SYSTEMS, INC.
Automated Gate and Access Control Products
413 Linden • Lusk, WY 82225 • (800) 223-2926
6
INSTALLING THE OPERATOR
! ADVISORIES!
A. THIS LINEAR ACTUATOR MUST ME MOUNTED SO THE PISTON FULLY EXTENDS AND
FULLY RETRACTS . WHEN FULLY RETRACTED THERE SHOULD BE 1/8 INCH PISTON LEFT
OUT OF THE FRONT.
1.
SCRIBE A LINE FROM THE HORIZONTAL SUPPORT OR DESIRED HEIGHT FOR THE
OPERATOR ON THE GATE LEAF ONTO THE GATE POST.
2.
CUT THE REAR MOUNTING BRACKET IN ACCORDANCE WITH THE DIMENSIONS
SPECIFIED ON THE MOUNTING GEOMETRY DETAIL.
3. WELD THE REAR MOUNTING BRACKET TO THE GATE POST.
4. DETERMINE THE “C” DIMENSION AND CUT THE FRONT MOUNTING BRACKET TO THE
PROPER LENGTH.
5. EXTEND THE PISTON TO FULLY EXTENDED POSITION FOR INWARD SWING GATES. THIS
CAN BE ACHIEVED BY TEMPORARILY CONNECTING THE CONTROL PANEL TO THE
OPERATOR AND USING THE MOTOR TO EXTEND THE PISTON, PRODUCING 9 7/8” OF
PISTON. IT IS VERY IMPORTANT WITH THE “600A” THAT THE PISTON
“BOTTOMS OUT IN
BOTH DIRECTIONS” .
6. SCREW THE “I” BOLT INTO THE END OF THE PISTON TO OF THE LENGTH OF THE
THREADS. ATTACH THE FRONT BRACKET TO THE OPERATOR.
7. ATTACH THE OPERATOR TO THE REAR MOUNTING BRACKET.
8. WITH THE GATE IN THE FULL CLOSED POSITION, LEVEL THE OPERATOR AND SCRIBE
THE LOCATION FOR THE FRONT MOUNTING BRACKET.
9. REMOVE THE FRONT MOUNTING BRACKET FROM THE FRONT OF THE GATE OPERATOR
AND WELD IT TO THE GATE LEAF AT THE SCRIBED LOCATION.
10.
REATTACH THE OPERATOR TO THE FRONT MOUNTING BRACKET.
11. ATTACH AN 18/4 STRANDED S.O. CORD APPROVED FOR OUTDOOR USE AS PER THE
STRAIN RELIEF ASSEMBLY TO THE OPERATOR PER THE ELECTRICAL CONNECTION
DETAILS.
NOTE: IT IS HELPFUL TO INSTALL A SINGLE GANG WEATHER PROOF BELL BOX ON THE GATE
POST ACROSS FROM THE OPERATOR. THEN WIRE FROM THE CONTROL BOX CAN BE PULLED TO
THIS POINT AND CONNECTED TO THE S.O. CORD INSIDE THE BELL BOX.