
6
3.
Twist the wheel arm all the way up (toward the top of the
carrier).
4.
Verify that the button is protruding through the hole in the
outside face of the receiver.
5.
Repeat the preceding two steps for the left wheel arm.
6.
Install the quick-release axle (with washer and two
springs) through the wheel axle then install the nut. Make
sure the small diameter of each spring is toward the wheel
(reference the provided pictures).
7.
Insert the wheel into the dropout of the wheel arms.
8.
Open and close the quick-release lever with your right
hand while gradually tightening the nut with your left
hand.
9.
Continue tightening the nut until you feel resistance when
the lever is the middle position (between fully open and
fully closed).
10.
Grip the wheel arm with your fingers and use the palm of
your hand to close the lever.
11.
When the lever is at the close position, it will be parallel
to the wheel arm and the inscription “CLOSE” (on the side
of the lever) will be facing away from the wheel.
12.
Check by pulling the wheel as hard as you can with one
hand while holding the wheel arm with the other hand.
Removal
Procedure:
1.
Open the quick-release axle and remove the wheel (you
might need to loosen the nut slightly).
1.
Press down the button with one hand and while the button
is pressed down, twist the wheel arm all the way down
(toward the floor of the carrier).
2.
Pull the wheel arm out.
Tracking Adjustment
Test your jogging stroller with all tires properly inflated and
with no load in the jogging stroller. If the jogging stroller rolls
to one side (rather than rolling straight), apply the following
procedure.
Procedure:
Jogging Stroller Rolling to the Right:
1.
Remove the jogger wheel (16” front wheel).
2.
Loosen the nut holding the dropout of the RIGHT wheel
arm.
3.
Pull the dropout outward approximately 3.5mm (1/8 inch).
The dropout can move up to 7mm (1/4 inch).
4.
Tighten the nut, install the wheel and test again.
5.
If the jogging stroller is still rolling to the right, repeat
steps 1-4 (with pulling the dropout outward all the way).
Jogging Stroller Rolling to the Left:
1.
Repeat the preceding procedure on the LEFT wheel arm.
Storage
Procedure:
Jogger Arms:
1.
Open the zipper of the cargo compartment that is closest
to the seat back.
1.
Insert the jogger arms in the cargo so that the end with
the dropout is completely inside the cargo compartment
and the other end is pointing upward (reference picture).
2.
Close the zipper to hold the jogger arms in place.