12
5. Charge Bar
Having set the display on the control panel, you will notice that during normal operation,
there is a charge bar running along the bottom of the display. This charge bar shows the
percentage of water softener capacity remaining since the last regeneration. Immediately
following a regeneration, the charge bar returns to 100%.
6. Resetting the display during normal operation.
If the time is to be adjusted during normal operation, press any key to illuminate the
display, press the
keys will alter the time as described on page12.
key once. The display will flash and indicate present time. Using the
7. Power loss
The AMECS system will maintain the individual programming parameters of the water
softener for up to 72 hours.
If the power cut lasts longer than 72 hours, the control will flash "0:00" when power is
returned to the control. The unit will continue to keep time from the moment power is
restored. In this situation, the time of day will need to be reset.
P
RA
T
EE
R
HT
8. Flow indicator
During normal operation, a flow indicator will flash on the display at a rate of one litre per
pulse when water is passing through the softener.
9. Cleaning
Your water softener may be cleaned using a damp cloth and a mild detergent. Do not use
bleaches, solvents or spirits as they may damage the surfaces.
4. Setting the Type of Salt. (See Fig4) “For WS455 and WS555 models only
To operate effectively, your water softener must be set to the type of salt that you intend to
use in the system. Block salt (BS) and care cubes (CC) are suitable. Use the
keys to select the type of salt used.
Pressing the button will return the display to the Normal Operation mode.
Programming is now complete and now further adjustments of the water softener is
required.
Remember to check the salt and water level in the brine cabinet weekly.
13
Set
00:00
Time
12
1. SETTING THE TIME OF DAY (see Fig1)
The first two digits (00) of the display will flash, prompting the installer to set the time.
The time is adjusted by using the keys. Pressing the key enters the hours.
The minutes are set by using the
keys
Pressing the
key once enters the minutes and moves the display into the Set
Hardness mode.
.
Set
00:00
Time
2. SETTING THE WATER HARDNESS (see Fig2)
The display default is 300 (typical hardness level) which indicates a setting suitable for
hard water with a value of 300 parts per million of hardness minerals. Use the
keys to adjust the setting to match that of the one you obtained / identified earlier. See
page 11 for details.
Pressing the set key once enters the hardness and moves the display to Set
Recharge Time Mode.
Hardness
Set
300
PROGRAMMING PROCEDURE
PAR
T
TWO
Set
02:00
RECHARGE Time
Fig1
Fig2
Fig3
3. SETTING THE RECHARGE TIME (see Fig3)
To operate effectively, your water softener needs to regenerate periodically (dependent
on the hardness of the supply and amount of water used). The default time of day when
this is to occur is 2.00am. To alter this setting, use the
keys.
Pressing the key once enters the recharge time and returns the display to Normal
Operation Mode and no further adjustment of the water softener is required.
WSINST 20pp A5 Seot 2017.indd 12
08/09/2017 08:43
