BWT PERMAQ Compact 951, Инструкция по установке и эксплуатации, Страница: 5 / 48

EN
5
1 General
This assembly and operating instruction
applies BWT PERMAQ Compact 950 total
desalination plants.
This assembly and operating instruction
contains important information about correct
installation and operation of the BWT
PERMAQ Compact 950 plant, consequently
the following is very important:
1. Enclosed ”Start-up control” shall be
filled in during commissioning and
filed along with the operating logbook.
2. The operating logbook shall be
updated as described under
”Enclosures”.
3. There must be a floor drain in
proximity of the plant. The drain shall
be dimensioned to the max flow from
the feed water.
4. The BWT PERMAQ Compact 950
plant removes 95-98 % of all salts. It is
possible to post-treat with a mixed-bed
or similar if a better water quality is
requested.
5. The instruction should be read carefully
before assembly and start-up of the
plant. Correct installation and service
will be a condition for our 12-month
warranty.
Therefore, read this instruction before
assembling or starting up the plant.
Your BWT PERMAQ Compact 950 plant is
made in a compact design with reservoir tank,
softening plant and reverse osmosis plant
joined in one unit to take up a little space as
possible.
Your BWT PERMAQ Compact 950 plant with
its compact and good finish is easy to install
since all internal installations are pre-fitted and
tested in our workshop.
Your BWT PERMAQ Compact 950 plant is
designed for minimum service and for long
and unproblematic operation.
However, this is on condition of correct
installation and maintenance.
You should therefore read this instruction
before taking the plant into use.
2 Definitions
There will be some technical words in this
instruction, which we have explained below.
Permeate:
Is the treated, totally desalinated water which
is produced by the RO plant and supplied to
the reservoir tank.
Concentrate:
The water which is led to drain. This water
contains the salts and minerals which have
been removed from the water.
Raw water:
The water which is led to the RO plant and
which shall be desalinated.
TDS:
The amount of dissolved salts measured in the
unit mg/l.
Conductivity:
A designation for the salt concentration of the
water, measured in the unit μS/cm. The lower
the number, the better is the water quality.