465U-HHEBD-4
3
MENU SETTINGS
Press the “MENU” button (button 2) to bring up the programming selections. Pressing the “MENU” button
again will cycle through the selections as follows:
Frequency
→
Power Level
→
Unit Number
→
then back to frequency if pressed again.
FREQUENCY
The frequency number from 1
– 8 should be displayed on the bottom line. Pressing the Power/Select
button will bring up a blinking cursor and allow the frequency to be changed. Press the Power/Select
button until the desired frequency is selected then Press Menu to save. The display should show
Saving….. then “Done” when complete.
POWER LEVEL
The power level, either “Low”, “Mid”, or “High”, should be displayed on the bottom line. Pressing the
Power/Select button will bring up the blinking cursor and allow the power level to be changed to any of
the aforementioned settings. Press the Power/Select button to change the setting then the Menu button to
save the setting.
UNIT NUMBER
When first received the transmitter Unit number will be “None”. This must be set to either Unit #1 or Unit
#2 before the transmitter can be used. The Unit number will be saved in EEPROM memory so that it will
always save this setting. It will be cleared back to “None” if “Clear” is selected.
Press the Power/Select button to bring up the flashing cursor. Pressing Power/Select again will cycle
through Unit # 1
…Unit #2...Clear. Press “Menu” when the correct unit number is selected to save the
setting. You’ll see “Saving…” then “Done” when complete.
SYSTEM ON/OFF
SYSTEM ON
Depress and hold the Power/Select button. The display
will show 3….2….1… then “Power On” when the
unit has turned on. Release the Power/Select button and the unit will begin to transmit a beacon signal to
the receiver approximately every 0.5 seconds
NOTE: If Unit Number hasn’t been set the display will show “Select Unit # First”. See the “UNIT
NUMBER” section in “MENU SETTINGS”
SYSTEM OFF
Depress and hold the Power/Select button. The display will count down 3…2…1 then “Power Off” when
the unit has turned off. At this point the beacon will stop and a log out code will be transmitted to the
receiver. This will turn off the corresponding ‘login’ relay on the receiver and allow the transmitter to log
back in later
NOTE: If the Power/Select button is released at any point during the power on/off countdown the unit will
stay in its current state and the countdown timer will reset.
