BWI Eagle AIR-EAGLE XLT 44UL-2000-DC, Информационный бюллетень о продукции

Страница: 2 / 4

AIR-EAGLE
®
XLT
900 MHz RF Receiver
MODEL 44UL-2000-DC
RELAY MODES OF OPERATION
Auto Reset (Maintained Momentary)
When signal is received from an authorized transmitter, the relay will
energize. The relay will maintain the energized state as long as the
transmitter is sending the signal. The relay de-energizes when the
transmitted signal stops.
Toggle Reset (Toggle Latch)
When a signal is received from an authorized transmitter, the relay will
energize and latch. The relay stays energized until the same signal is
received again, at which time it unlatches and de-energizes.
Latching Reset (True Latch)
When a signal is received from an authorized transmitter, the relay will
energize and latch. The relay stays energized until a different signal is
received from the transmitter, at which time it unlatches and de-energizes.
i.e.
– Transmission from Input 1 of authorized transmitter energizes and
latches relay 1. Transmission from Input 2 of an authorized transmitter de-
energizes relay 1.
RELAY & FREQUENCY SET-UP
The unit is shipped from the factory with SEL1 switches in the open
positions. All four relays will operate as maintained momentary and unit is
receiving commands on frequency one. If you wish to change these
default settings, follow the instructions on the table below.
1) Remove power from unit
2) Remove top cover.
3) Select desired relay operation and/or network frequency using table
below.
4) Reattach cover and apply power.
5) Programming is now complete.
RELAY CONFIGURATION
SEL1
SWITCH
NUMBER
OPEN CLOSED
SW1 Relay #1 momentary (default) Relay #1 toggle/latch
SW2 Relay #2 momentary (default) Relay #2 toggle/latch
SW3 Relay #3 momentary (default) Relay #3 toggle/latch
SW4 Relay #4 momentary (default) Relay #4 toggle/latch
FREQUENCY SET-UP
SEL1
(SW5-7)
Network
Frequency
SW5 SW6 SW7
1 (default) OPEN OPEN OPEN
2 CLOSED OPEN OPEN
3 OPEN CLOSED OPEN
4 CLOSED CLOSED OPEN
5 OPEN OPEN CLOSED
6 CLOSED OPEN CLOSED
7 OPEN CLOSED CLOSED
UL SPECIFICATIONS & CLASSIFICATIONS
SPECIFICATIONS
DC Input 10
– 24 VDC @ 10 Watts
Relay Contacts SPDT 5 amp @ 120VAC or 30VDC
Fuse Protected 1 amp
Receiver Frequency 900 MHz Spread Spectrum
Receiver Range
Approximately 2500 feet (Up to 4 miles
with external high gain antenna)
Receiver Channels Seven independent network frequencies
Operating Temperature -10
o
C to +55
o
C
Altitude Under 2000 meters
Enclosure Polycarbonate, IP66 Approved
Weight Approx 2 lbs.
CLASSIFICATIONS
Automatic Control and Electrically Operated Control
Incorporated Control and an Independently Mounted Control
Type 1.C Action; Micro-Interruption
PTI of Materials Used for Insulation: Material Group IIIb
Electrical Shock Risk: Class II Control
Period of Electrical Stress Across Insulating Parts Supporting Live
Parts: Long Period
Pollution Degree 2
Number of Cycles of Activation: 30,000 (Relay)
DIMENSIONS
Page 2