PRODUCT INFORMATION
BULLETIN
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
AIR-EAGLE
®
XLT
900MHz RF Repeater
MODEL 441-4500-DC
DESCRIPTION
The A
IR
-E
AGLE
XLT
RF
R
EPEATER IS
designed to retransmit an RF
signal from any Air-Eagle XLT Transmitter. When placed in an area
where the signal is weak, this unit will then re-transmit at full strength
facilitating greater distances and allowing the RF signal to reach
around corners, through tunnels, over hills and through valleys.
APPROVALS
United States (FCC)
MCQ-XB900HP
Canada (IC)
1846A-XB900HP
INSTALLATION
DISCONNECT DC Power from all equipment before installation.
1.
Mount the A
IR
-E
AGLE
XLT REPEATER in a convenient location.
2.
Attach rubber duck antenna or coax from external antenna to
connector on side of enclosure.
3.
Connect supplied power input cable to your external power source.
TERMINAL STRIP WIRING
TERMINAL STRIP WIRING (TER1)
Terminal 1
(-) 9-36VDC INPUT
Terminal 2
(+) 9-36VDC INPUT
Terminal 3
Not Used
Terminal 4
Not Used
Terminal 5
Not Used
Terminal 6
Not Used
Terminal 7
Not Used
Terminal 8
Not Used
Terminal 9
Not Used
Terminal 10
Not Used
Terminal 11
Not Used
Terminal 12
Not Used
Terminal 13
Not Used
Terminal 14
Not Used
*AC Powered Model Pictured
CONTROLS & INDICATORS
RX LED
Yellow LED illuminates as remote signals are
being received by the repeater
POWER LED
Green LED is illuminated while power is
applied to the repeater
TX LED
Red LED illuminates as remote signals are
being re-transmitted by the repeater
RF1
RF module that receives data from the remote
transmitter
SEL1
Used to set frequency
