PRODUCT INFORMATION
BULLETIN
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
AIR-EAGLE
®
SR
2.4 GHz RF Transmitter
MODEL 38-1500
DESCRIPTION
The A
IR
-E
AGLE
SR PLUS TX
I
s a handheld R.F. transmitter capable of
sending up to sixteen unique digital commands to an Air-Eagle SR
Receiver located up to 300 feet away. Any number of transmitters and
receivers can be combined to create a short range radio frequency
system that operates hazardous or hard-to-reach equipment from safe,
convenient locations. Eight user-programmable frequencies allow
multiple systems to operate simultaneously in the same area without
interference. This transmitter will automatically go into “sleep” mode
when no buttons are being depressed on the unit to dramatically
extend battery life.
APPROVALS
United States (FCC)
OUR-XBEEPRO
Canada (IC)
4214A-XBEEPRO
Europe (CE)
ETSI
INITIAL OPERATION SET-UP
This transmitter comes ready to operate, with batteries installed, and
factory programmed to Frequency #1. No setup is necessary unless you
wish to change frequencies.
For example, if you are setting up this transmitter to use with an
existing system that is operating on Frequency #1, no change in this
setting is necessary. However, if you wish to operate this unit with a
receiver on another network, follow the programming procedure on the
next page to change the frequency setting appropriately
Dimensions: 4.72” L x 2.56” W x .88” D
(Note – belt clip adds .48” to depth)
CONTROLS & INDICATORS
TX LED
LED illuminates “
RED
” continuously while
button is depressed and unit is transmitting.
When this LED blinks briefly following a
transmission, the battery needs to be
replaced. See note*
Pushbuttons 1 thru 8
Transmit individual button RF codes to the
receiver
Pushbutton P/Shift
The P/Shift button performs two functions:
1. If button is depressed momentarily and
another button is then pressed within 3
seconds, the higher code for that button is
transmitted. This allows for transmission of
pushbutton codes 9 thru 16.
2. If button is depressed for longer than 3
seconds, the transmitter will enter
“programming” mode. See PROGRAMMING
section.
Pushbuttons 9 thru 16
Used to communicate with a second receiver
– will activate Relays 1 thru 8
INDIVIDUALLY in the second receiver (no
dual relay activation capability)
