BW Broadcast ModMon Encore, Руководство пользователя

Страница: 14 / 37

7 - 1
Installation & Operation
7
7.1 QUICK SETUP
Install the ModMon Encore into the rack; The unit should be mounted in a grounded, 19”
(483mm) equipment rack. While the ModMon Encore generates little heat itself, it could
be damaged by being confined between other heat-generating equipment. If the
equipment directly below or above the ModMon Encore runs hot, you should allow one
single rack space between them.
The area directly to the rear and sides of the unit should be open, to allow free-flowing
air, and the environment should be as dust-free as possible.
1. Connect AC power to the unit;
2. Connect two antenna inputs;
3. Connect the analogue or digital output to an amplifier and speakers;
4. Set the receive frequencies of the two tuners in the menu Presets|Preset
Name|Tuner 1 Freq and Tuner 2 Freq;
5. Use the red and green buttons to switch between the two tuners.
Further information on each parameter is contained in the following sections of this
manual.
7.1.1 AUDIO CONNECTIONS
The analog audio outputs are balanced XLR connectors (pin 2 +ve) and can range from
peak levels of -10dBu to +24dBu. The menus in the ModMon Encore are used to calibrate
the audio levels to suit your facility.