BVM
®2017
5
08/04/2017
Begin assembly by removing and inspecting all airframe components. Carefully become
familiar with the wiring, landing gear, gear doors, etc. The BVM F-18 PNP is not meant to be
a primary turbine trainer. The manual assumes you already have experience with high
performance turbine aircraft.
Installing the Horizontal Stabilizers
Use a 9/64” driver to secure the
horizontal stabilizers. Be Sure to install
the white plastic washer between the
stabilizer and fuselage.
Final centering adjustments should be
made during radio setup.
NOTE: the stabilizer is not fully seated to show
the plastic washer.
The Neutral point of the stab is 3" below vertical fin junction
at the L.E.
Installing The Wings
Use a 9/64” driver to secure the front
and rear clamp bolts.
