Ultra Bandit EVO
Assembly & Operation Manual
BVM ® 2019
7
11/12/2019
MOUNTING THE EZ HANGER
The EZ Hanger is mounted to the
tank using 2 #4 counter sunk wood
screws. The tank has 2 predrilled
holes where it mounts.
NOTE: There are 2 longer 4-40 bolts
that come with the EZ Hanger. These
will get used in the next step.
Once the EZ Hanger is on the
tank, remove the 4-40 bolt from
the collar. Using your Dremel
make a slot on the inside of the
tank, use the longer 4-40 bolt to
extend through the side of the
tank and into the collar. This is
what will remove your tank.
MOUNTING THE TANKS
Using the cardstock supplied cut out the card tool
to fit around the carbon flex plate. Tape the
template to the wing. Using the drill sizes on the
template drill the wing accordingly.
