BV Medical Vib-Mesh HL100, Руководство пользователя, Страница: 19 / 31

19
Troubleshooting
Please refer to the table below to troubleshoot any problems you may encounter
when using the nebulizer.
Problems Possible Causes Solutions
Extremely low
nebulization.
Medication chamber is not
completely attached.
Re-attach the medication
chamber correctly and restart
the power. (See page 6)
No contact between
medication and mesh for more
than 10 seconds.
Adjust the nebulizer’s angle so
the medication can come in
contact. (See page 11)
Mesh of medication chamber is
clogged.
Clean the medication chamber.
If it still cannot be used after
cleaning, please replace with a
new medication chamber.
(See page 13~15)
Electrodes on medication
chamber are clogged with
medication or water.
Clear the electrodes of clogged
medication or water and restart
the power. (See page 14)
Electrodes on nebulizer and
medication chamber are
stained.
Remove the stains and restart
the power. (See page 14)
After turning power
on, power indicator
lights for one
second and then
immediately goes
out.
Medication chamber is not
completely attached.
Re-attach the medication
chamber correctly and restart
the power. (See page 6)
No medication in medication
chamber.
Put in the medication in the
medication chamber.
(See page 9~10)
No contact between
medication and mesh.
Adjust the n
ebulizer’s angle so
the medication can come in
contact. (See page 11)
Electrodes on nebulizer and
medication chamber are
stained.
Remove the stains and restart
the power. (See page 14)
Power indicator is
not lit and nebulizer
is not nebulizing.
Batteries installed backwards. Re-install the batteries in the
correct orientation and restart
the power. (See page 7~8)
Nebulisers.net.au