3
TM
1
7
8
9
10
11
2
3
4
5
6
12
13
14
15
HOPPER & RETAINER
See Fig.1 on pg. 2
Slide the hopper onto the sleeve below until the
holes in the hopper line up with the holes in the
frame tube. Install hopper retainer (4) using two
3/8-16 x 3 hex cap screws (15) and two 3/8-16 x 1
hex cap screws (12) from the outside of the retainer
through the retainer, tube and hopper. Install 4
large flat washers (14) inside hopper and 4 smaller
3/8 flat washers (11) outside retainer. Secure
hopper to frame with 4 3/8-16 nuts (13). Install the
cover latch keepers (16) onto the hopper using
#10-24 socket head screws (18) and nuts (17). Make
sure the keeper (16) is facing down with the screws
on top and that the screw head is on the outside
and the nuts are on the inside. Install the cover
latches (19) onto the cover using #10-24 socket
head screws and nuts. Insert the screw thru the
inside of the cover so that the nuts are on the
outside of the cover.
Bill of Materials
1
3005473
1
Frame, Welded, TGSUV1A w/Sleeve
2
3007502
1
Gate, Flow Adjuster, TGSUV1B
3
30081391
4
Washer, Flat 1/4 SAE SST
4
–
2
Screw, HHC - 1/4-20 x 1-1/2 SS
5
3007508
2
Spring, Gate, TGSUV1
6
–
2
Nut, Nylon Insert 1/4-20 SST
7
3005693
1
Motor, 12VDC, 1000 RPM, 1/8 HP w/SAE Conn.
8
–
4
Washer, Flat 1/4 SAE, Zinc/Clear
9
–
4
Screw, Cap 1/4-20 x 3/4 SST
10
–
4
Washer, 1/4 in. Spring Lock SST
11
–
4
Nut, Hex 1/4-20 SST
12
3007809
1
Hub, Spinner, TGSUV1 w/Set Screw Installed
13
3005705
1
Spinner, Poly, TGSUV1
14
1420014
1
Pin Clevis, 1/4 x 2.5
15
–
1
Cotter Pin, 5/64 x 3/4
item
part no.
qty.
description
Fig. 2
