5
TM
BATTERY
VIBRATOR
PART #3007416
CONTROLLER
PART #3008623
POWER CABLE
PART #3008615
WIRE HARNESS
PART #3008620
FUSE CONNECTOR
CONNECTOR TO FUSE TERMINAL
OR IGNITION SWITCH
2-PIN CONNECTOR
4-PIN CONNECTOR
GEAR MOTOR
PART #3015377
Installing Controller and Wiring
• Route both wire harnesses into truck cab through firewall (it
maybe necessary to drill holes). Insulate hole to avoid water leaks.
• Insure no wires are nicked or damaged during installation.
• Connect the 4-pin connecter on the wire harness to the control
box.
• Connect the 2-pin connector on the power cable to the control
box.
• Connect fuse connector to the fuse terminal or ignition switch.
• Lay out a path for the power cable to the battery, use quick ties
to secure power cable.
DO NOT CONNECT TO BATTERY AT THIS
TIME!
• Lay out path for wire harness to the rear of the vehicle. It is rec-
ommended to stay clear of the exhaust system. Excess heat can
damage the wire harnesses. Use quick ties to secure harness to
underbody.
• Connect the wire harness to the motor and vibrator.
• Connect the power and ground cables directly to the battery.
• Insure all functions of the controller are working properly.
•
Note: direction of spinner may be changed by interchanging the
motor leads.
Spreader Operation
Due to the rate at which materials absorb moisture
differently, some materials may not perform as desired. Therefore,
the substitution of an alternative material may
be necessary for optimum performance of the spreader.
CAUTION: When filling hopper, make certain there are no large
objects/ debris contained in the material, which could cause auger
to bind and stop operation of the spreader.
CAUTION: Material must never be left in the hopper for extended
periods of time when spreader is not in use. Material will bind,
harden and may damage spreader.
Maintenance Instructions
• Periodically inspect spreader for loose bolts and nuts.
• Inspect for broken wires, frayed or cracked insulation.
• Lubricate bearing every 10-15 hrs. using general
automotive grease.
THIS IS WIRE GROUND ELECTRICAL SYSTEM!
NO CONNECTIONS TO TRUCK’S FRAME OR BODY ALLOWED!
NOTE: Always disconnect battery before attempting to install
electrical components on your vehicle.
Mount the controller in a convenient location
in the truck cab. It is recommended not to mount the controller
directly in front of heat vents. Allow ample air space around
controller.
CAUTION
DO NOT MOUNT CONTROLLER IN THE WAY
OF AIR BAG DEPLOYMENT!
