background image

1

9049 Tyler Blvd. • Mentor, Ohio 44060

Phone (440) 974-8888 • Fax (440) 974-0165

Toll-Free Fax 800-841-8003 • saltdogg.com

Installation Instructions

—continued inside

SHPE2000, SHPE2000RED, SHPE2000YEL 

Series SaltDogg

®

 Electric Drive Poly Hopper 

Spreader
2.0 cubic yards

U.S. PATENT 9,562,333

Serial Number 21000 and Above.

Table of Contents 

General Information .....................................................................1
Safety Precautions .......................................................................1
Warranty Information ...................................................................2
Installation Instructions ............................................................ 2-4
Spreader Operation .....................................................................5
Spreader Maintenance .................................................................5
Repair Parts & Drawings .........................................................6-10

General Information 

Spreader models:

 

  • SHPE2000- spreader with standard length chute
  • SHPE2000X- spreader with extended length chute

Overall Length:

 96 inches 

Overall Width:

 48 inches 

Overall Height: 

(installed): 41.5 inches

Empty Weight:

 560 lbs. (standard chute), 564 lbs. (extended chute)

Capacity Struck: 

2.0 cu. yd. 

Average Installation Time: 

3 hrs.

Vehicle Requirements 

• 3/4 or 1 ton pick-up truck above 8500# GVWR. 
• 135 AMP or higher alternator is recommended. 

Materials Recommended to Spread

SHPE2000 SALTDOGG SPREADER WARRANTY INFORMATION

This warranty replaces all previous warranties and no employee of this 
company is authorized to extend additional warranties, or agreements, or 
implications not explicitly covered herein. 

Buyers Products Company warrants all parts of the product to be free 
from defects in material and workmanship for a period of two (2) years. 
Parts must be properly installed and used under normal conditions. 
Normal wear is excluded.

Any part, which has been altered, including modifications, misuse, acci-
dent, or lack of maintenance will not be considered under this warranty.

The sole responsibility of Buyers Products Company under this warranty 
is limited to repairing or replacing any part(s), which are returned, pre-
paid, 30 days after such defect is discovered, and returned part(s) are 
found to be defective by Buyers Products Company. 

Authorization from Buyers Products Company must be obtained before 
returning any part. The following information must accompany defective 
parts returned to Buyers Products Company: RMA #, spreader model, 
serial number, date installed, and distributor from whom purchased.

Buyers Products Company shall not be liable for damage arising out of 
failure of any unit to operate properly, or failure, or delay in work, or for 
any consequential damages. No charges for transportation or labor per-
formed on any part will be allowed under this warranty.

CAUTION

Do not overload vehicle beyond the vehicle’s GVWR or GAWR. 
Check vehicle's load rating certification sticker for maximum 
vehicle capacity.

Average Material Weights

Materials to use  

Weight (pounds per cubic yard)

Fine Salt-Dry  

2,250

Coarse Salt-Dry  

1,431

Sand/Salt up to 50/50 Mix-Dry 

2,700

Note:

 To calculate the total spreader weight (including ice 

control material), add the empty spreader weight plus the ice 
control material and spreader accessories.

Содержание SaltDogg SHPE2000









Отзывы: