2
TM
Adjusting Spinner Zero Settings
1.
Verify that the spinner knob is turned completely
CCW to the zero position before beginning
adjustments.
2.
Make sure that spinner disk has stopped, if it is
rotating, see step #3
3.
Using a paperclip (that has been straightened
out) depress the "set" button that is located
between the two led displays on front of controller
to put controller into "adjustment mode".
4.
Using the "speed" buttons below the spinner
display, press the "Right" speed button to decrease
the output to the spinner disk.
5.
After spinner stops rotating, use the paper clip
to depress the "set" button to lock-in setting.
Adjusting Spinner Span Settings
1.
Verify that the spinner knob is turned completely
CW to the max speed position you want before
beginning adjustments.
2.
Check to see that spinner disk is spinning at
desired speed then proceed to step #3
3.
Using a paperclip (that has been straightened
out) depress the "set" button that is located
between the two led displays on front of controller
to put controller into "adjustment mode".
4.
Using the "speed" buttons below the spinner
display, press the "Left" speed button to increase
the output to the spinner disk if it is rotating to
slow.
5.
After spinner is rotating at desired speed, use
the paper clip to depress the "set" button to lock-in
setting.
Adjusting Auger Zero Settings
1.
Verify that the Auger knob is turned completely
CCW to the zero position before beginning
adjustments.
2.
Make sure that Auger is stopped, if it is moving
proceed to step #3
3.
Using a paperclip (that has been straightenened
out) depress the "set" button that is located
between the two led displays on front of controller
to put controller into "adjustment mode".
4.
Using the "speed" buttons below the Auger
display, press the "Right" speed button to decrease
the output to the Auger motor.
5.
After Auger stops moving, use the paper clip to
depress the "set" button to lock-in setting.
Adjusting Auger Span Settings
1.
Verify that the Auger knob is turned completely
CW to the max speed position you want before
beginning adjustments.
2.
Check to see that auger is moving at desired
speed then proceed to step #3
3.
Using a paperclip (that has been straightened
out) depress the "set" button that is located
between the two led displays on front of controller
to put controller into "adjustment mode".
4.
Using the "speed" buttons below the Auger
display, press the "Left" speed button to increase
the output to the auger until desired speed is
achieved.
5.
After Auger is moving at desired speed, use
the paper clip to depress the "set" button to lock-in
setting.
Setting Blast Time
1.
Check to make sure the Auger speed knob is
NOT turned to full speed before beginning blast
time adjustment.
2.
Press the " blast button" on the front of the
controller to initiate the "blast" function.
3.
Using the same paper clip that was used for
spinner and auger adjustments, depress the "set"
button between the two led displays to enter
setting mode.
4.
The auger display will show "BT", using the
"speed" buttons below the auger display, press the
"left" button to increase the blast time or press the
"right" button to decrease the blast time.
5.
Use paper clip,press the "set" button again to lock
in value.
